Girard Associates, Inc. & Girard Engineering, Inc. - Cleveland, Ohio - Forging and Industrial Controls / Enclosures

Technical Data for Hotmatic Hotformer: AMP 30S

	AMP 30S (metric)	AMP 30S (English)
>>> Working Range
Initial weight	50 - 700 g	.11 - 1.55 lb
Maximum outer diameter for round parts	67 mm	2.64 in
Maximum outer diameter for combination blanks	58 mm	2.28 in
Maximum width across flats (hex)	60 mm	2.36 in
Bar diameter	18 - 40 mm	.71 - 1.57 in
Cut-off length	20 - 72 mm	.79 - 2.85 in
>>> Performance Data
Strokes per minute (infinitely variable)	85 - 140	85 - 140
Total tonnage	2500 kN	2500 kN
Drive Motor	67 kW	55 kW
Tooling:
Center distance of dies	160 mm	6.30 in
Forming stations	3	3
1st station	125 mm	4.92 in
2nd station	160 mm	5.90 in
3rd station	125 mm	4.92 in
>>> Strokes
Main slide	160 mm	6.30 in
Ejectors	70 mm	2.76 in
>>> Utility Requirements
Electrical:
Power supply	120 kVA	120 kVA
Cooling Water:
Pressure	4 bar	60 psi
Maximum flow rate (depends on forging)	30 m^3/h	100 cu. ft/h
Compressed Air:
Pressure	5.5 - 10 bar	80 - 145 psi
Consumption (noncompressed state)	3 Nm^3/h	100 cu. ft/h
>>> Dimensions and Weights
Length	5000 mm	197 in
Width	3700 mm	146 in
Height	2000 mm	90.55 in
Feed line above floor	1100 mm	43 in
Weight	36 t	79000 lb